Kinugawa Toyota 1HZ diesel td05h-16g spec turbocharger with 3" anti-surge cover and 7cm Bolt-on turbine housing provides ultimate spool time than ever. The turbocharger is equipped with CT26 base turbine housing (inlet and outlet type) the same as the factory turbocharged 1HDT Land Cruiser engine. If you have an HZJ80 series, a factory 3″ exhaust system will fit straight on, the turbocharger is the same bolt pattern as the factory turbocharger, and in the same factory location. HZJ75, HZJ79, HZJ105 models will require an exhaust shop to connect. Some exhaust system companies already make a Turbocharger exhaust for these models but please check with your local exhaust shop.
- Kinugawa TOYOTA 1HZ 4.2L Diesel 300HP Limited
- 75/78/79/80/100 series TD05H-16G with 7cm Bolt-on turbine housing for fast spool
- Compressor wheel: 49.5 / 68.0 mm Point Milling / Third-order Surface
This high-performance 68mm compressor blends quick response and top-end power with OE reliability. The billet 16KX billet compressor wheel utilizes their latest generation blade aero with 7 primary blades and 7 splitter blades.
|Ruled Surface||Free Surface|
|Process||Flank Milling||Point Milling|
|Machining Time||Quick 15 mins.each||Slow 120 mins.each|
|Characters||1. Ruled Surface can be produced by Flank Milling
2. Low efficiency
3. Only suitable to the very easy design of compressor wheel
4. Mainly for fundamental mechanical engineering such as Centrifugal compressor
|1. Free Surface can be only produced by Point Milling
2. More air pressure and increase much better flow efficiency.
3. Mainly for high efficiency turbochargers.
- Turbine wheel: 56 / 49.2 mm Inconel 713
The 9 blades STS (Superior Turbine Strike) turbine wheel. This will take a shorter time to build a boost and at higher RPM won't choke because it's less restrictive than an 11 or 12 blade turbine.
- Compressor inlet: 3 " Anti-surge AR 60 with Speed Sensor Port
- A/R: 7cm (.49) CT26 Bolt-on
- Journal Bearing system with 360-degree performance thrust bearing
-oil and water cooling
- Default 1.0bar The drive will go with the turbo.
-We have 0.5bar, 0.8bar, 1.2bar, 1.5bar, 1.7bar, and 2.0bar drives, Please add a comment to your order if you need to change it.
- Default 1.0bar. We offer 0.5bar, 0.8bar, 1.2bar, 1.5bar, 1.7bar, and 2.0bar spring preinstalled, too. Please add a comment to your order if you need to change it.
- The peak pressure setup is limited: 2.8bar
- Suggested pressure setup: 1.5bar
The set includes
-1 x Oil supply set
-1 x water coolant and return set
-1 x ct26 gaskets
-Full balance from Schenk MBRS 950 110 Germany
-Kinugawa Turbo Systems