Application
- Kinugawa TOYOTA 1HZ 4.2L Diesel 330HP Limited
- 75/78/79/80/100 series TD05H-16KX with 6cm T3 V-Band Turbine housing, You need an exhaust manifold with a T3 flange if you want to install this turbocharger on a 1HZ Engine.
The maximum power stated for each turbocharger has been calculated based strictly on the choke flow of the compressor map (total turbo capability), which represents the potential flywheel power. Performance results of this product are highly dependent upon your vehicle’s modifications and tuning/calibration.
CHRA Size
- TD05H-16K
Wheels Spec
- Compressor wheel: 49.6 / 68.0 mm Point Milling Third-order Surface. This high-performance 68mm compressor blends quick response and top-end power with OE reliability. The billet 16K (aka 16KX) billet compressor wheel utilizes their latest generation blade aero with 7 primary blades and 7 splitter blades.
| Free Surface | Ruled Surface | |
| Process | Point Milling | Flank Milling |
| Machining Time | Slow 120 mins.each | Quick 15 mins. each |
| Characters |
1. Free Surface can be only produced by Point Milling |
1. Ruled Surface can be produced by Flank Milling 2. Low efficiency 3. Only suitable to the very easy design of compressor wheel 4. Mainly for fundamental mechanical engineering such as Centrifugal compressor |
- Turbine wheel: 56 / 49.2 mm
Note: The 9 blades STS (Superior Turbine Strike) turbine wheel. This will take a shorter time to build a boost and at higher RPM won't choke because it's less restrictive than an 11 or 12 blade turbine.
Compressor Housing
- Compressor inlet: 3 " Anti-surge AR 60 with Speed Sensor Port
Turbines Housing
- A/R: 6 cm .41
- Turbine input: T3
- Turbine outlet: 2.5" v-Band internal wastegate
Bearing Type
- Journal bearing system with 360-degree performance thrust bearing kit
Cooling Type
- oil and water cooling
Actuator Pressure
- Default 1.0bar. We offer 0.5bar, 0.8bar, 1.2bar, 1.5bar, 1.7bar, and 2.0bar spring preinstalled, too. Please add a comment to your order if you need to change it.
Boost Level
- The peak pressure setup is limited: 2.8bar
- Suggested pressure setup: 1.5bar
The set includes
- 1 x Oil supply set
- 1 x water coolant and return set
- 1 x T3 gasket
- 1 x V-Clamp and V-Band Socket Adapter Kit 2.5"
- 1 x Turbocharger
- 1 x Balance Report with Anti-Counterfeit Tag
Situation
- Brand New
- Full balance from Schenk MBRS 950 110 Germany
Provider
-Kinugawa Turbo Systems
Guarantee
-One year
You might also like
From
$899.00
From
$899.00
`